adaptech@nic.fi                    DESCRIPTION                  090791-ADAPWIPE
                        
                                           10.12.00 (1)
 







THE ADAPWIPE 



        
        "AdapWipe" -  Adaptive Windscreen Wiper Control.
        
        
          I:  Controlswitch is in position "0", the rain is watering the windscreen. 
         
         II:  There is a need to wipe the windscreen, so ...
        
        III:  ... You move the controlswitch to position '1' and ensue from that is a wipe. 
         
         IV:  There comes a need to wipe the windscreen again, so move the controlswitch 
              from position '0' to position '1' and now keep the switch in that position!! 
              "AdapWipe" repeats the saved interval. 



        
THE CIRCUITS
        
        This is easy to install to the usual system.
        (Not for instance MAZDA 626, where the external connections  are literally avoided.)
 
        You have to find a wire which has a voltage in position '1' and then 
        You cut that wire. After that You install the "ADAPWIPE" between the break of wire 
        just like the circuits diagram  ADAPWIPE.ISS it shows.(Immediately after the switch!)   
           
        The other possible windscreen wiper functions are  still in use. 
        
        !. The windscreen wiper's motor has a contactor, which connect the holding-current. 
        Either the relay in "AdapWipe" do not switch the current off! The circumstances those
        who are stated above can pay attention to, when choosing the relay.   

        
THE CANDY
        
        Put the controlswitch to position '1' BEFORE You turn the ignition key.
        (After that you refer the controlswitch back to position '0'.)
        You get two wipes instead of one. 
        The mentioned circumstance may come useful, if the wipers are in bad condition!
        
        
THE PROBLEM
                                                      
        ... where to find a ground?